Buckeye Truck Roller Bearings Black

Buckeye Truck Roller Bearings Black

Buckeye 33 inch Roller Bearing Trucks in Black. These trucks are created with the origin at the center of the wheel on the Z Axis and aligned to the center of the bolster for the X and Y axis. You will need the truck/bogey attachment points aligned to the center of the bolster and at a height of 16.5 inches. This truck/bogey may be used on any freeware content. It is equipped with LOD, bump mapping, animation and a shadow mesh. If you wish to use this on payware, please contact me.

Author: LilB(Brian Snook)

Buckeye Truck Roller Bearings Black
• anim.kin 4.09KB
• brakes.im 125.36KB
• brakes.kin 4.65KB
• buckeye.im 801.33KB
• buckeye.lm.txt 211 bytes
• buckeye_bump.texture.txt 60 bytes
• buckeye_bump.tga 3.00MB
• buckeye_roller.texture.txt 37 bytes
• buckeye_roller.tga 3.00MB
• buckeyelow.im 206.00KB
• buckeyemid.im 540.88KB
• config.txt 2.13KB
• shadow.im 81.97KB
• thumbnail.jpg 36.57KB

This item may not be used under any circumstances in payware content without writen permission from Brian Snook. Please contact me if you want to reskin this asset.
Any attempt to reverse engineer this mesh, in part or whole, will result in legal action.
All logos and registered trademarks are property of their copyright holders.
Author of this content takes no responsibility for any damage that this content may cause from it's use.
Copyright 2013 Brian Snook All Rights Reserved

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE107: The high-detail meshes total more than 10000 polygons. This may have a negative impact on performance: 0: 12176, 1: 8457, 2: 3682
VE109: The low-detail meshes total more than 500 polygons. This may have a negative impact on performance: 0: 12176, 1: 8457, 2: 3682