Barber S1 33inch Trucks CN Red

Barber S1 33inch Trucks CN Red

Barber S1 33 inch Trucks in CN Red. These trucks are created with the origin at the center of the wheel on the Z Axis and aligned to the center of the bolster for the X and Y axis. You will need the truck/bogey attachment points aligned to the center of the bolster and at a height of 16.5 inches. This truck/bogey may be used on any freeware content. It is equipped with LOD, bump mapping, animation and a shadow mesh. If you wish to use this on payware, please contact me.

Barber S1 33inch Trucks CN Red
• anim.kin 3.20KB
• barber-s1.texture.txt 32 bytes
• barber-s1.tga 768.04KB
• barber33.im 328.24KB
• barber33.lm.txt 220 bytes
• barber33low.im 76.99KB
• barber33lowest.im 1.16KB
• barbers1_norm-barbers1_norm.texture.txt 61 bytes
• barbers1_norm.tga 768.04KB
• config.txt 1.97KB
• lowest-lowest.texture.txt 47 bytes
• lowest.tga 16.04KB
• shadow.im 45.36KB
• thumbnail.jpg 27.81KB