Barber S1 33inch Trucks Black

Barber S1 33inch Trucks Black

Barber S1 33 inch Trucks in Black. These trucks are created with the origin at the center of the wheel on the Z Axis and aligned to the center of the bolster for the X and Y axis. You will need the truck/bogey attachment points aligned to the center of the bolster and at a height of 16.5 inches. This truck/bogey may be used on any freeware content. It is equipped with LOD, bump mapping, animation and a shadow mesh. If you wish to use this on payware, please contact me.

Author: LilB(Brian Snook)

Barber S1 33inch Trucks Black
• anim.kin 3.20KB
• barber-s1.texture.txt 32 bytes
• barber-s1.tga 768.04KB
• barber33.im 328.24KB
• barber33.lm.txt 220 bytes
• barber33low.im 76.99KB
• barber33lowest.im 1.16KB
• barbers1_norm-barbers1_norm.texture.txt 61 bytes
• barbers1_norm.tga 768.04KB
• config.txt 2.12KB
• lowest-lowest.texture.txt 47 bytes
• lowest.tga 16.04KB
• shadow.im 45.36KB
• thumbnail.jpg 27.35KB

This item may not be used under any circumstances in payware content without writen permission from Brian Snook. Please contact me if you want to reskin this asset.
Any attempt to reverse engineer this mesh, in part or whole, will result in legal action.
All logos and registered trademarks are property of their copyright holders.
Author of this content takes no responsibility for any damage that this content may cause from it's use.
Copyright 2013 Brian Snook All Rights Reserved

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.