LMS3F Engine Spec

LMS3F Engine Spec

LMS 3F Engine Spec. Thanks to Jacob Cash and Eric Whitmore

Author: Tony Weber

LMS3F Engine Spec
• config.txt 5.67KB
• thumbnail.jpg 46.85KB

This engine specification table has been developed specifically to simulate the performance of an LMS Fowler 3F 'Jinty' but may be used on any loco you may wish.

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE61: Required tag 'blower-effect' was missing and has been set to default.
VE61: Required tag 'blower-max-flow' was missing and has been set to default.
VE61: Required tag 'boiler-efficency' was missing and has been set to default.
VE61: Required tag 'boiler-efficency-idle' was missing and has been set to default.
VE61: Required tag 'boiler-efficency-min' was missing and has been set to default.
VE61: Required tag 'cutoff' was missing and has been set to default.
VE61: Required tag 'firebox-heating-surface-area' was missing and has been set to default.
VE61: Required tag 'hand-brake-max-force' was missing and has been set to default.
VE61: Required tag 'ideal-coal-mass' was missing and has been set to default.
VE61: Required tag 'max-coal-mass' was missing and has been set to default.
VE61: Required tag 'number-cylinders' was missing and has been set to default.
VE61: Required tag 'number-power-strokes' was missing and has been set to default.
VE61: Required tag 'speed' was missing and has been set to default.
VE61: Required tag 'steam-chest-max-flow' was missing and has been set to default.
VE61: Required tag 'steam-chest-volume' was missing and has been set to default.
VE61: Required tag 'super-heating-constant' was missing and has been set to default.
VE61: Required tag 'valve-lap-percent' was missing and has been set to default.
VE62: Required container 'thumbnails' is missing.