MoveTurntable

MoveTurntable

Moves turntable to a specified stop position. As a prerequisite, you need to download and install 'InputTable' rule (kuid:131986:1012) from DLS. Then, edit this rule and enter the following on a new line:

turntable, turntable_name, number_of_stops

where turntable_name denotes the name of the turntable object in Surveyor and number_of_stops is thel number of stop positions (minimum 2) in the turntable.

Ex: turntable,Turntable 1, 10 (name of the turntable is 'Turntable 1' and the number of stop points around the turntable is 10)

Once this statement is entered in the 'InputTable' rule, you will notice that the name and the stop numbers (listed as 0,1,2,...) is seen in the menu of MoveTurntable command in the driver setup rule. This menu also includes 'next' and 'prev' options to move the turntable incrementally, if desired. Choose a turntable and one of its available stops that you wish turntable to move and assign this operation to one of the drivers using the turntable. Note that the turntable stop numbers are ordered in the clockwise direction and it starts with 0 as being the the default turntable stop.

VERSION: 1.01 (small fix)

MoveTurntable
• config.txt 2.36KB
• moveturntable.texture.txt 26 bytes
• moveturntablecommand.gs 3.76KB
• moveturntableschedulecommand.gs 2.26KB
• tag.bmp 48.05KB
• thumbnail.jpg 7.23KB