Hicapyflat 3 body

Hicapyflat 3 body

Some flatcar loads while relativly small were be so heavy they exceded the axle loading limit for a standard (2 bogie) flatcar.
Several Railroads modified flatcars by replacing the normal 2 bogies with two bolsters with bogies at each end which then attached to the
underside of the car body in the same manner as the original single bogie. This reduces the axle loading by almost half. This is the body section
with a large electrical transformer as a load. Assemble this car in Surveyor by placing the body section on the track then select the bolster
(kuid2:210518:6501:1) and place them half way between the center of the car and each end.

Author: Benjamin R. Dorsey

Hicapyflat 3 body
• black.bmp 3.05KB
• black.texture.txt 28 bytes
• brass.bmp 822 bytes
• brass.texture.txt 28 bytes
• config.txt 2.73KB
• dark grey.bmp 12.05KB
• dark grey.texture.txt 32 bytes
• hicapyflat_3_body.im 1.03MB
• light grey.bmp 822 bytes
• light grey.texture.txt 33 bytes
• white flat.bmp 48.05KB
• white flat.texture.txt 33 bytes
• wood2.jpg 121.70KB
• wood2.texture.txt 28 bytes

This item is offered free of charge for your enjoyment. It may not be sold or used in any commercial venture. It may be re-skinned for your personal use.