NSWGR catenary wire spline for sharply-curving double to single track transitions, LH

NSWGR catenary wire spline for sharply-curving double to single track transitions, LH

A catenary wire spline to transition from a double-track catenary spline (assets 30134-30137 in this series) to 2 single-track catenary splines (assets 390120-30131) on a gentle curve.
The starting spline point must attach to the double-track catenary spline and the terminal (second) spline point must attach to a single-track catenary spline. No intermediate spline points are allowed when laying this spline.
If the starting spline point is at the terminating end of the double-track catenary spline, then this spline will represent the continuation of the left-hand catenary of the double-track catenary spline.
The gap between the double-track and single-track terminating spline points for joining must be between 15 and 35m. This spline will bridge such a gap without repeats.
Suitable for track with a curvature radius between 200 and 450m. For gentler curves use <kuid:368725:30142>. The default height of the pickup wire above the railtop is 5.3m, midway within the NSW operating range of 4.75 to 5.8m.
The model meshes are based on those in a workbook provided by David Owen (Davido). Thanks to David for sharing his work.

NSWGR catenary wire spline for sharply-curving double to single track transitions, LH
• catenary-lod0.im 18.45KB
• catenary-lod1.im 17.04KB
• catenary-lod2.im 3.78KB
• config.txt 3.03KB
• thumbnail.jpg 27.10KB
• wire.texture.txt 27 bytes
• wire.tga 48.04KB