NSWGR throw-over lever to switch yard points, default left, for avatar operation

NSWGR throw-over lever to switch yard points, default left, for avatar operation

A throw-over lever that is weighted to hold the active switch blade against the stock rail in the selected switch direction.
When used with junctions formed with tracks from the series sourced from <kuid2:368725:49000:7> 'Protrack NSWGR Mesh Library', this asset mates with the switching mechanism when it is mounted to the right side of a junction that is switched left by default.
The lever is normally operated by a safe-working officer (SWO) avatar (see the 'SWO Controller Rule' <kuid:368725:60021>). When the relevant avatar is active in the yard in which this control is placed, AI drivers cannot control the junction. When the avatar leaves the trigger area of this junction it will remain in switch direction to which it has been set.
A naming convention is required so that each junction in a yard is linked to the yard's avatar. If the avatar location code is <location code> then the ground point lever must be named <location code>_TPL_<sequence>, where <sequence> is a lever sequence alphanumeric. For example, if the avatar location code is 'CNJ' then a valid point lever code is 'CNJ_TPL_4'.

NSWGR throw-over lever to switch yard points, default left, for avatar operation
• config.txt 2.75KB
images
close.jpg 844 bytes
tpl_n.jpg 1.30KB
tpl_on.jpg 1.30KB
• junctionlever_yard_v5.gs 24.06KB
• lever1.lm.txt 231 bytes
• lever1_0.im 95.86KB
• lever1_1.im 55.53KB
• lever1_2.im 32.19KB
• lever2.lm.txt 231 bytes
• lever2_0.im 95.86KB
• lever2_1.im 55.41KB
• lever2_2.im 31.62KB
• throwover lever-throwover lever.texture.txt 65 bytes
• throwover lever.tga 1.00MB
• throwover lever_normal-throwover lever_normal.texture.txt 104 bytes
• throwover lever_normal.tga 1.00MB
• thumbnail.jpg 35.73KB