Oil Pump Rotoflex Unit

Oil Pump Rotoflex Unit

A Rotoflex oil pumping unit built by wheatherford. This unit uses a belt ran by a reversable motor which winds the belt up to pull the pump rod up, it then reverses and unwinds the belt to lower the pump rod. The advantage of this design over a typical pump jack is this unit can pull the rod up to 25.5 feet on each stroke where as the conventional units have only a 30 inch to 10 foot stroke, depending on there size.
The unit name of each one can be changed in surveyor using the ? mark button.

Author: BNSF50

Oil Pump Rotoflex Unit
• 2 button switch.texture.txt 38 bytes
• 2 button switch.tga 24.53KB
• arm pivot.texture.txt 32 bytes
• arm pivot.tga 768.53KB
• concrete oiley.texture.txt 37 bytes
• concrete oiley.tga 48.53KB
• config.txt 2.72KB
• env_metal.bmp 12.05KB
• env_metal.texture.txt 32 bytes
• expanded metal grating1-expanded metal grating1.texture.txt 81 bytes
• expanded metal grating1.tga 64.53KB
• many colors2.texture.txt 35 bytes
• many colors2.tga 1.28KB
• motor.texture.txt 28 bytes
• motor.tga 12.53KB
• oil streak.texture.txt 33 bytes
• oil streak.tga 48.53KB
• pumping unit.im 205.38KB
• pumping unit.kin 30.88KB
• rotoflex unit.wav 544.79KB
• screenshot.jpg 17.21KB
• stand.texture.txt 28 bytes
• stand.tga 3.53KB

This item is supplied free of charge for personnel use by registered users of Trainz. It or its contents must not be modified, offered for sale or supplied as any part of a Payware package or provided for downloading on any site other than Auran unless this is expressly permitted in writing by the author BNSF50 / Clem Cummings.

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE109: The low-detail meshes total more than 500 polygons. This may have a negative impact on performance: 0: 3862