Yuan Gulch - Session 4 MoW

Yuan Gulch - Session 4 MoW

This session is for the Yuan Gulch RRCo layout. All the required dependencies are either built-in or from the Download Station.

Important information about this session, in particular the method used to load and unload freight cars, can be found in the N3V Trainz Forums. Search for Yuan Gulch.

Note
When using the Tincup Mine loop it might be difficult to change the setting of Junction 138. If so, use the Map View (make sure under Map Display Options, top left, there is a tick against Junctions) and click on the red/green arrows of the switch to change the setting
You will need to take the role of Road Master to decide where to spot the freight cars for unloading. Some pre-planning about switching movements and whether the locomotive should be in the lead or rear of the consists may be needed.

Chuck and Joe, Depot Foreman here. Thanks for coming out this morning at short notice.
Two boxcars have jumped the rails at the Log Camp Freight House. The Road Master is there already with a couple of his crew.
He wants you to take rails, sleepers and ballast up there. And also our excavator.
We will use the two log skeletons at the sawmill for the rails and the two flats at Steamship for the sleepers. Load all four at MoW.
We have two loaded ballast cars at Ore Mill Bulks and the rest of the MoW crew will travel on the two cabooses standing at the Gulch Freight Depot.
The excavator is more problematic. It will not fit through the tunnel. I’ve arranged to have it barged across to the Dock at the far side of the switchback and loaded onto a flat car. By the time you have got the MoW gear there the excavator should be ready to go.
When the Road Master no longer needs help return the empty freight cars and sign off.
I have given you our little 2-4-2T yard switcher.

Yuan Gulch - Session 4 MoW
• config.txt 14.30KB
• profile.dat 59.34KB
• profile.lyr 28 bytes
• profile.obs 527 bytes
• profile.rlr 36 bytes
• profile.trk 260 bytes
• thumbnail.jpg 128.19KB