Autopilot Command

Autopilot Command

This command sets the train to autopilot mode. The driver will obey all signals but doesn't change junctions. It is the user's responsibility to set the correct path. To use the command it must be added to the Driver Command Rule in Surveyor.

The command has two options:

- activate:
Activates the autopilot on a train. The train runs forever, the only way to stop it is to abort the command.

- stop at trackmark:
The train drives until it reaches a selectable trackmark. When the trackmark is reached the next command is executed (or the train is stopped).

When the command is used in conjunction with the autopilot rule it is possible for drivers to leave trains which have autopilot enabled. The rule will remember the state of the autopilot even on unattended trains and keeps them running. If a driver returns to an autopilot train the command is added to the schedule again.

Special thanks to André Vaillancourt for the french translations.

Author: Martin Hammel (_mutton_)

Autopilot Command
• autopilot.tga 16.02KB
• autopilot_command.jpg 8.13KB
• autopilotcommand.gs 2.85KB
• autopilotcustomcommand.gs 670 bytes
• autopilotschedulecommand.gs 1.85KB
• config.txt 15.63KB
• prettymenu.gs 6.17KB

Copyright (c) 2005 Martin Hammel

This package may be distributed freely, as long as the package's content is not altered and no fees are charged. It is not allowed to reuse parts of the package like, but not limited to, bitmaps or scripts, in other projects.

This package or parts of the package must not be used in or distributed together with products that are charged like, but not limited to, so-called 'payware' without express permission of the author.

The package is provided on an 'as is' basis,

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.